cmlaigaie
Jul 4 2004, 09:50 AM
Can I use a 130mm rear hub in a bmx application?
raybeard
Jul 4 2004, 11:08 AM
Typical BMX is 100mm front and 110 mm rear. Some 26 inchers use a 130 rear like the later SE OM Flyers. This was because they were a MTB crossover.
The hub bodies SHOULD be the same between the 110 and the 130. If so the only difference would be the axle and axle spacers. You might be able to get the correct 110 mm hardware from Bullseye to use on a 130 mm hub.
[ July 04, 2004, 01:10 PM: Message edited by: raybeard ]