Ok i got some AJK Repo Haro master decals. which i'm putting on my 95 master. It's at the powder coaters now. I am thinking i will have to cut the decals to fit the down tube as it's bigger than the 88 master Downtubes.
but then I'll have a gap in the center of the downtube.
What will i do just leave it? i don't want to buy another set of decals to cut a center stip out of the downtube decal to fit it.

unless someone has a downtube decal they are not using and want to sell it alone.
or even a scrap peice with the center intact that i could fit it.

Or one more way. could i scan My decal and print it on some decal paper? or would it not match?
i need it for a black set.

Devon

they will wrap from the top to the bottom so the gap should be at the bottom. but the new ones are also made with the brake cable hangers cut out too. i dont think you will have a problem other then the wording will ride a bit high on the side but not enough to notice it.