Not much to go on here. 27.5" wide (probably cut a little), 6.5" rise (center to center), knurled clamp area, nice-looking welds. No engraving or stamping, tragically. This may be better suited to mid school, but I figured it would get more looks here. Thanks.

My guess is Elf ?

Those looks the same as the late 80's early 90's robinson cruiser bars I run.
No name stamp on them, Just a sticker.
Mine still have the original sticker.

However the knurling looks a bit different ,
yours are more like the knurling from revcore, so I would have to say they are either REVCORE or BRACKENS.
flapjaqz

Hm. I can buy that more than Elf—Elf bars (as far as I remember) had a larger diameter, higher crossbar and a narrower base. I think.

Thanks.

The late 80's-early 90's Robinson bar cruiser bars had the word "cruz" stamped into the grip area on one side of the bars. The same as GT cruiser bars of the same era.
The bend looks very similar to some Elf bars that I have known. I don't know if Brackens made cruiser bars. Their 20 inch bars had an octagon shaped cross bar.

Robinsons were more narrow at the bottom. I think they're GTs.

The crossbar is a bit crooked...