Welcome Guest ( Log In | Register )

Reply to this topicStart new topic
Willie S.
post Jan 9 2005, 10:42 PM
Post #1


Group: Members
Posts: 126
Joined: 2-December 04
From: Park Forest, Il
Member No.: 5,048

Has anyone had any experience with this? I'm thinking of having some simple parts stripped and redone. I'm just wondering about the expense, where to locate people that do this, and what I should look out for/be aware of.
Go to the top of the page
+Quote Post
post Jan 10 2005, 11:32 PM
Post #2


Group: Members
Posts: 204
Joined: 10-March 04
From: serfCITY.....CA
Member No.: 3,365

I'd stick with someone local to you and not ship parts far away unless you live out in the sticks (then I'd ship them with FedEx Ground...cheaper and trackable). Look under plating or metal finishers in your local yellow pages.
But before you go to that trouble I can tell you that most shops who handle anodizing have batch charge minimums so if you only have a couple of small parts it WILL be expensive. Time to round up your VBMX homies and get them on the same page colorwise and then it will work out financially.
Go to the top of the page
+Quote Post
post Jan 15 2005, 11:00 AM
Post #3


Group: Members
Posts: 31
Joined: 6-December 04
From: 20,000 ft
Member No.: 5,068

make sure you get hard (0.0015" approx) it will not scratch/rub/wear as easily as soft/normal (0.0007"approx).

also, try to polish before as its a far superior finish.
Go to the top of the page
+Quote Post

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:


Lo-Fi Version Time is now: 23rd May 2018 - 08:31 PM